Tar Oxidation plant

Automatic control with a minimum number of attendants - two people. Ease of maintenance, there are enough specialists of average technical qualification for work (the possibility of training specialists at their own installation with an internship in Chelyabinsk). Possibility of regulation in each received product of necessary parameters. It is possible to obtain road and construction bitumen. The installation does not produce any waste, does not require additional communications (steam, gas, sewerage, etc.). The equipment used works at many enterprises, and has proven itself well, including in Kazakhstan and Uzbekistan. The equipment is safe, none of the plants has experienced any unforeseen circumstances, and the first units of this series were put into production nine years ago.
The equipment works according to the traditional principle, it does not contain revolutionary solutions that have not been tested by time. The world's best vermiculite-based heat-resistant heat-insulating brick is used in the furnace, which eliminates heat loss, therefore, the furnace efficiency is the best in the industry. Also in the furnace, one of the most advanced block burners in the world made in South Korea is used. These burners have a simple design. Efficiency compared to Russian counterparts is 30% higher. Excellent stability in work, availability of spare parts. The advanced principle of operation of furnaces is applied (the flame of the burner does not just pass through the furnace furnace, as in most designs, but reaches the baffle, then cuts along the outer side of the coil block, once again giving off heat to heat the raw materials through the chimney, it enters the heat recuperator, where preheating takes place raw materials with exhaust gases, which contributes to the complete selection of heat at this installation.
The unit is provided with a heat recovery system using heat exchangers, which saves both electricity and fuel for the burners.
The oxidation column has a factory-made two-layer heat-insulating coating. The modes of oxidation processes are controlled by sensors, the information from which is sent to the control panel. Due to this, the operator can regulate the conditions under which the rectification process takes place, which makes it possible to process tar of various characteristics.